Bill Text: NC H889 | 2011-2012 | Regular Session | Amended


Bill Title: Amend Locksmith Licensing Act/Increase Fees

Spectrum: Partisan Bill (Republican 4-0)

Status: (Engrossed - Dead) 2012-06-29 - Ref To Com On Finance [H889 Detail]

Download: North_Carolina-2011-H889-Amended.html

GENERAL ASSEMBLY OF NORTH CAROLINA

SESSION 2011

H                                                                                                                                                   2

HOUSE BILL 889

Committee Substitute Favorable 6/26/12

 

Short Title:        Amend Locksmith Licensing Act/Increase Fees.

(Public)

Sponsors:

 

Referred to:

 

May 5, 2011

A BILL TO BE ENTITLED

AN ACT amending the locksmith licensing act and authorizing the north carolina locksmith licensing board to increase certain fees.

The General Assembly of North Carolina enacts:

SECTION 1.  G.S. 74F‑3 reads as rewritten:

"§ 74F‑3.  Licenses required.

No person shall perform or offer to perform locksmith services in this State unless the person has been licensed under the provisions of this Chapter. A violation of this section is a Class 31 misdemeanor unless the conduct is covered under some other provision of law providing greater punishment."

SECTION 2.  G.S. 74F‑4 reads as rewritten:

"§ 74F‑4.  Definitions.

The following definitions apply in this Chapter:

(1)        Apprentice. – A person who has been issued an apprenticeship designation by the Board.

(1a)      Board. – The North Carolina Locksmith Licensing Board.

(2)        Code book. – A compilation, in any form, of key codes and combinations.

(3)        License. – A certificate issued by the Board recognizing the person named therein as having met the requirements to perform locksmith services as defined in this Chapter.

(4)        Locksmith. – A person who has been issued a license by the Board.

(5)        Locksmith services. – Repairing,Services that include repairing, rebuilding, rekeying, repinning, servicing, adjusting, or installing locks, mechanical or electronic locking devices, access control devices, egress control devices, safes, vaults, and safe‑deposit boxes for compensation or other consideration, including services performed by safe technicians. The definition also includes any method of bypassing a locking mechanism of any kind, whether in a commercial, residential, or automotive setting, for compensation.

(6)        Locksmith tools. – Any tools that are designed or used to open a mechanical or electrical locking device in a way other than that which was intended by the manufacturer."

SECTION 3.  G.S. 74F‑9 reads as rewritten:

"§ 74F‑9.  Fees.

The Board shall establish fees not exceedingin the following amounts:

(1)       Issuance of a license                                                               $100.00$300.00

(2)       Renewal of a license                                                               $100.00$300.00

(3)       Examination                                                                            $200.00

(4)       Reinstatement                                                                         $150.00$250.00

(5)       Late fees                                                                                $150.00$300.00

(6)       Apprentice license fee                                                             $100.00$300.00

(7)       Apprentice transfer fee                                                             $25.00."

SECTION 4.  G.S. 74F‑10(b) reads as rewritten:

"(b)      All licenses shall expire three years after the date they were issued unless renewed. All applications for renewal shall be filed with the Board and shall be accompanied by the renewal fee as required by G.S. 74F‑9. A license that has expired for failure to renew may be reinstated after the applicant pays the late renewal, late, and reinstatement fees as required by G.S. 74F‑9. If an applicant whose license has expired can show good cause to the Board the reason for allowing the license to expire, the Board, in its discretion, may adjust the renewal and reinstatement fees accordingly."

SECTION 5.  G.S. 74F‑12(b) reads as rewritten:

"(b)      Every person advertising locksmith services performed by the person shall include in the advertisement the identification number that is printed on the license issued by the Board.All advertisements for locksmith services shall include a valid license number issued by the Board. The license number of the owner of the locksmith company shall satisfy the requirements of this subsection."

SECTION 6.  G.S. 74F‑15 reads as rewritten:

"§ 74F‑15.  Disciplinary procedures.

(a)        The Board may deny or refuse to renew, suspend, or revoke a license or apprenticeship designation if the licensee, apprentice, or applicant:

(1)        Gives false information to or withholds information from the Board in procuring or attempting to procure a license.

(2)        Has been convicted of or pled guilty or no contest to any of the crimes listed in G.S. 74F‑18(a)(2).

(3)        Has demonstrated gross negligence, incompetency, or misconduct in performing locksmith services.

(4)        Has willfully violated any of the provisions of this Chapter.

(b)        The Board may assess the costs of disciplinary action, including attorneys' fees, against an applicant or licensee found to be in violation of this Chapter or rules adopted by the Board."

SECTION 7.  G.S. 74F‑16 reads as rewritten:

"§ 74F‑16.  Exemptions.

The provisions of this Chapter do not apply to:

(1)        An employee of a licensed locksmith when acting under the direct control and supervision of the licensed locksmith. For purposes of this subdivision, 'direct control and supervision' means that a licensed locksmith is required to physically accompany the employee to the premises where locksmith services are to be performed.

(1a)      An employee of a locksmith company performing administrative duties only. For purposes of this section, 'administrative duties' means managing the daily operations of an office in a locksmith company, including performing clerical tasks, answering telephones, and greeting customers.

(2)        A person working as an apprentice pursuant to G.S. 74F‑7.1.

(3)        A person or business required to be licensed or registered by the North Carolina Alarm Systems Licensing Board pursuant to Chapter 74D of the General Statutes, when acting within the scope and course of the alarm systems license or registration.

(4)        An employee of a towing service or an automotive repair business providing services in the normal course of its business, a repossessor, a taxi cab service, a motor vehicle dealer as defined in G.S. 20‑286(11), or a motor club as defined in G.S. 58‑69‑1 when opening automotive locks in the normal course of their duties, so long as the employee does not represent himself or herself as a locksmith.

(5)        A property owner, or the owner's employee, when providing locksmith services on the property owner's property, so long as the owner or employee does not represent himself or herself as a locksmith. For purposes of this section, "property" means, but is not limited to, a hotel, motel, apartment, condominium, commercial rental property, and residential rental property.

(6)        A merchant, or retail or hardware store, when it lawfully duplicates keys or installs, services, repairs, rebuilds, reprograms, rekeys, or maintains locks in the normal course of its business, so long as the merchant or store does not represent itself as a locksmith.

(7)        A member of a law enforcement agency, fire department, or other government agency who, when acting within the scope and course of the member's employment with the agency or department, opens locked doors to vehicles, homes, or businesses.

(8)        A salesperson while demonstrating the use of locksmith tools to persons licensed under this Chapter.

(9)        A general contractor licensed under Article 1 of Chapter 87 of the General Statutes when acting within the scope and course of the general contractor license, or an agent or subcontractor of a licensed general contractor when acting within the ordinary course of business.

(10)      A person or business when lawfully installing or maintaining a safety lock device on a wastewater system when the safety lock device is required by permit or requested by the owner of the wastewater system, provided the person or business does not represent itself as a locksmith. For purposes of this subdivision, "wastewater system" has the same meaning as in G.S. 130A‑334.

(11)      Any person or firm that sells gun safes or locking devices for firearms when acting within the scope and course of the sale of gun safes or locking devices for firearms.

(12)      A person while performing a locksmith service in an emergency situation without receiving any compensation for this service and who does not advertise those services."

SECTION 8.  This act is effective when it becomes law.

feedback